Chapter 4. Diagnostics and Troubleshooting 4-7
April 20, 1999 10:38 am
CardBus Ready Port Adapter with Modem to send and
receive data simultaneously when connected to a full-
duplex hub.
LINESPEED
(For 16-bit DOS Drivers) Forces operation to 10 or 100
Mbps. If the keyword is not present the line speed will be
automatically detected.
LINESPEED
(For 32-bit NDIS3 Driver IBMC.SYS) Forces operation to
10 or 100 Mbps. Valid parameters are AutoDetect, 10
Mbps, and 100 Mbps.
LINKDISABLE
Disables link integrity for non-IEEE 10BASE-T networks
such as StarLAN 10. Without this keyword in the driver
command line, the driver defaults to link integrity
ENABLED.
MEM, MEMORY
Specifies the host PC memory location for the EtherJet
CardBus Ready Port Adapter with Modem in
hexadecimal notation, when MODE MEMORY (memory-
mapped I/O) is being used (see MODE). The memory
block occupies 4 KB of host memory.
MODE
When set to IO, disables requests for memory-mapped
mode on systems that only support an I/O-driven card.
The MEMORY setting provides increased performance
on computers that allow simultaneous availability of
memory and I/O resources.
NETWORKADDRESS
Allows user to override EtherJet CardBus Ready Port
Adapter with Modem’s unique network node address by
specifying a different node address.
fhf0mstr.book Page 7 Tuesday, April 20, 1999 10:39 AM
