Chapter 3. Windows NT 4.0 Installation 3-3
April 20, 1999 10:20 am
Modem Setup
1.
After the computer has been restarted, select Modems from
the Control Panel.
2.
On the Install New Modem panel, make sure that the
check-box:
Don’t detect my modem; I will select it from a list
is not checked.
3.
Select Next. Windows NT will query the COM ports to find
the IBM modem.
4.
Select Next if the modem was found as IBM CardBus 56K
Modem. If a standard modem is found, select Change.
5.
On the Install New modem panel, select Have disk and type
the path to the IBM CD-ROM.
6.
Verify that the "IBM CardBus 56K Modem" is selected and
then select OK.
7.
On the Install New Modem panel, select Next.
8.
On the Install New Modem panel, select Finish.
9.
On the Modems Properties panel select Dialing Properties
to set up dialing properties (not necessary if a modem had
been previously installed). Select Close.
10. Select Start
➞
➞
➞
➞
Run. Type path/
SETUP.EXE
, where path/ is
the drive containing the IBM CD-ROM. IBM utilities and
online documentation will be installed in a program group on
your hard drive.
11. When prompted to reboot, select Yes. After the computer
restarts and Windows reloads, IBM CountrySelect will
launch. Make a country selection (U.S.A. is the default).
fhf0mstr.book Page 3 Tuesday, April 20, 1999 10:39 AM
