IAI Msep, Инструкция по эксплуатации

Страница: 243 / 296

Chapter 6
Troubleshooting
235
Alarm
Code
Alarm
Level
Alarm Name Cause/Treatment
0F5
Operation
release
Nonvolatile memory
write verify error
It is verified at the data writing process to the non-volatile
memory that the data inside the memory and the data to be
written are matched. There was a mismatch detected in this
process.
Cause : Faulty nonvolatile memory.
Treatment : When the error is caused even when the power is
re-input, please contact IAI.
0F6 Nonvolatile memory
write timeout
There is no response in the specified time duration during the
data writing to the non-volatile memory.
Cause : Faulty nonvolatile memory.
Treatment : When the error is caused even when the power is
re-input, please contact IAI.
0F8 Nonvolatile memory data
destroyed
Abnormal data was detected during the nonvolatile memory
check after starting.
Cause : Faulty nonvolatile memory.
Treatment : When the error is caused even when the power is
re-input, please contact IAI.
0FA CPU error The CPU operation is not normal.
Cause : 1) Faulty CPU.
2) Malfunction due to noise.
Treatment : When the error is caused even when the power is
re-input, please contact IAI.
0FC
Cold start
Logic error
(Component error in
controller)
The controller is not operating properly.
Cause : 1) Malfunction due to the effect of noise, etc.
2) Malfunction of peripheral circuit components.
Treatment : Turn the power OFF and reboot.
If the error occurs again, check for presence of
noise.
Also, if you have another controller, replace it and
try. A recurring error with the spare controller
suggests presence of noise.
If the cause cannot be identified, please contact
IAI.
100 to
1FF Message
Alarm on teaching tool [Refer to the Instruction Manual of teaching tool.]
200 to
2FF
Operation
release
Alarm on teaching tool [Refer to the Instruction Manual of teaching tool.]
300 to
3FF Cold start
Alarm on teaching tool [Refer to the Instruction Manual of teaching tool.]