50
[Emergency recording setup]
Configure the settings related to emergency recording
[Recording time]
Select a recording duration for the emergency recording.
30 s/ 1 min/ 3 min/ 5 min/ 10 min/ 15 min/ 30 min
Manual: Records only while the connected
external switch is being pressed. It records at
least 8 seconds.
Ext.: Alarm output will continue until the alarm
action is reset.
For details on canceling the alarm action, refer to the
"Cancel the alarm action" (
☞
Default:
30 s
[SD backup rec.]
Set whether to save the image on the SD memory
card or not when the communication is disconnected
during the recording.
On: Uses the SD memory backup function.
Off: Does not use the SD memory backup function.
Default:
Off
Important:
• It is recommended to use the SD memory backup
function with a wired network connection.
SD backup rec.
The SD memory backup is a function to save images
on the SD memory card inserted in the camera when
the recorder fails to communicate with the camera
during the set recording time.
The SD memory backup is only available if the
camera supports the SD memory recording and the
compression is set to H.264/H.265.
The SD memory recording is done by the registered
compression of the camera.
Note:
• If the camera is set to "Not use" the SD memory
card or the SD memory card is not inserted
(including insufficient insertion), error messages
are displayed some times in a day and recording
is paused for about 20 seconds.
• If the SD backup rec. function is used, set the
operation mode of the SD memory card to
"Overwrite On" from the camera side.
Acquire the image saved on the SD memory card
Acquire the image saved on the SD memory card to
the recorder and record it to the HDD.
Acquisition of images from the SD memory card is
automatically done a quarter past every hour.
(0:15, 1:15, ∙∙∙23:15)
You can check whether the recorder is acquiring the
SD memory data on the "Status display area".
Important:
• This features saves only image data to the HDD.
Audio data and information used in motion
detection search are not saved.
• When the recording starting time set on the
schedule has arrived without communication
between the camera and the recorder, the SD
memory backup will not be executed.
• Do not set the SD memory backup function to the
same camera from multiple network disk recorders.
• The recording time of the acquired SD memory
data will be time of the camera. Adjust time of the
camera and the recorder using the NTP function
and the camera time auto synchronization
function. If time is not adjusted, the SD memory
backup may not be available.
• After setting the SD memory backup function to
"On", manually acquire the SD backup data from
the camera. (
☞
day, data acquisition will be automatically
performed a quarter past every hour.
[Setup via recorder's main monitor]
