I-Bus IBC 2600, Руководство пользователя

Страница: 46 / 140

Chapter 2 - System BIOS
2-12 IBC 2600 User’s Guide
S
Select Auto-Detect Hard Disks to have AMIBIOS automatically detect
the type and parameters of each hard drive if you have IDE drive(s).
This option is described later in this section.
S
Select Change User Password to establish or change the password
for the user. This function is described later in this section.
S
Select Change Supervisor Password to establish or change the
password for the supervisor. This function is described later in this
section.
S
Select Auto Configuration with Optimal Settings to load the Optimal
default settings. These settings are best-case values which should
provide the best performance characteristics. This function is described
later in this section.
S
Select Auto Configuration with Fail Safe Settings to load the Fail
Safe default settings. These settings are more likely to configure a
workable computer, but they may not provide optimal performance.
This function is described later in this section.
S
Select Save Settings and Exit to store your changes in the CMOS.
The CMOS checksum is calculated and written to the CMOS. Control is
then passed back to AMIBIOS and the booting process continues,
using the new CMOS values. This function is described later in this
section.
S
Select Exit Without Saving to pass control back to the AMIBIOS
without writing any changes to the CMOS. AMIBIOS continues with the
booting process. This function is described later in this section.
AUTO-DETECT HARD DISKS
The Auto-Detect Hard Disks option allows you to have AMIBIOS auto-
matically detect the type of hard disk drive(s) in your system. The auto-
matic detection functions only if you have IDE drives. The parameters
are reported on the Standard CMOS Setup screen.
AMIBIOS searches first for the primary master and slave hard disk
drives, then for the secondary master and slave drives. If it can access a
drive, it reads the disk parameters. It then searches the AMIBIOS drive
type table for matching parameters to determine the disk type and dis-
plays both the type and parameters on the screen. If no matching param-
eters are found in the table, AMIBIOS specifies the type as ”User” and
fills in the parameter values it found on the drive. If it cannot access the
drive or if it is not an IDE drive, AMIBIOS times out and specifies that the
disk drive is ”Not Installed.”