Hyundai Seasall S220P, Руководство по ремонту

Страница: 83 / 150

Engine Electrical System 82 Starting System
Starter Brush Holder
Check that there is no continuity between the (
+
) brush
holder(A) and (-) plate(B). If there is continuity, replace
the brush holder assembly.
Overrunning Clutch
1. Slide the overrunning clutch along the shaft.
Replace it if does not slide smoothly.
2. Rotate the overrunning clutch both ways.
Does it lock in one direction and rotate smoothly in
reverse? If it does not lock in either direction of it
locks in both directions, replace it.
3. If the starter drive gear is worn or damaged, replace
the overrunning clutch assembly. (the gear is not
available separately)
Check the condition of the flywheel or torque
converter ring gear if the starter drive gear teeth are
damaged.
Cleaning
1. Do not immerse parts in cleaning solvent.
Immersing the yoke assembly and/or armature will
damage the insulation wipe these parts with a cloth
only.
2. Do not immerse the drive unit in cleaning solvent.
The overrun clutch is pre-lubricated at the factory and
sol-vent will wash lubrication from the clutch.
3. The drive unit may be cleaned with a brush
moistened with cleaning solvent and wiped dry with a
cloth.
Starter Relay
1. Remove the ECU box cover .
2. Remove the relay (A).
3. Using an ohmmeter, check that is continuity
Between each terminal .
4. Apply 12v to terminal 85 and ground to terminals 86
check for continuity between terminals 30 and 87.
5. If there is no continuity, replace the starter relay.
6. install the ECU box cover