Hyundai Seasall S220P, Руководство по ремонту, Страница: 34 / 150

Engine Mechanical System
33
Cylinder Head assembly
3) Install the LH gasket so that the identification mark
(A) faces toward the timing chain side.
4) Install the RH gasket so that the identification mark
(A) faces toward the transaxle side.
3. Install the cylinder head gasket (A) on the cylinder
block
✍
NOTICE
Be careful of the installation direction.
4. Place the cylinder head quietly in order not to
damage the gasket with the bottom part of the end.
◉
CAUTION
Put on a lid on the intake port or the water outlet fitting
in order for some materials such as bolts not to get
inside
5. Install the cylinder head bolts.
1) Tighten the eight cylinder head bolts on each bank,
in several passes, in the sequence shown.
Tightening Torque:
1st step: 58.8N.m (6.0kgf.m, 43.4lbf-ft)
2nd step: 90°± 2°
3rd step: 120°± 2°
✍
NOTICE
Do not reuse the cylinder head bolts more than twice.
6. Install the timing chain case bracket (A). Tighten the
vertical-direction bolts slightly first and then the
horizontal-direction ones and the vertical-direction
ones with the specified torque below.
Tightening Torque:
19.6 ~ 25.5Nm (2.0 ~ 2.6kgf.m, 14.5 ~ 18.8lb-ft)