Hyster N30ZDR, Руководство пользователя

Страница: 16 / 28

Load Rollers Repair
1.
Remove the rear frame from the mast as re-
quired to remove and install the load rollers.
See Reach Carriage Assembly.
WARNING
Be careful when removing or installing snap
rings. Snap rings can eject during removal or in-
stallation with enough force to cause an injury. Al-
ways use the proper snap ring pliers and wear eye
and face protection during removal or installation.
2.
Remove the snap rings from the load rollers.
See Figure 5.
1. SNAP RING
2. LOAD ROLLER
3. SPACER
4. STUB SHAFT
Figure 5. Load Roller Assembly
NOTE:
Lightly pry the load roller from the stub
shaft if necessary. See Figure 6.
3.
Remove the load roller from the stub shaft. Re-
place as necessary.
1. LOAD ROLLER (WITH SNAP RING REMOVED)
2. PRY BAR
3. REAR FRAME
Figure 6. Removing Load Roller (6.9 Mast)
(N30ZDRS and N35-40ZRS)
NOTE:
Tag and identify the shim packs for each
roller.
4.
Remove the shims from the stub shaft.
5.
Use a cloth to clean each load roller. Inspect the
load rollers for cracks, flat spots, or bearings
that do not turn freely. Replace any roller that
shows wear or is damaged.
Load Rollers Repair 4500 SRM 1196
10