Hyster N30ZDR, Руководство пользователя

Страница: 22 / 28

INSTALL
WARNING
The points between the scissor arms and the front
frame is a pinch point and can cause an injury.
DO NOT put any part of your body between these
assemblies. Use a screwdriver or other tool to
move the bearing blocks or assemblies into the
correct positions.
1.
Use multipurpose grease to lubricate the bush-
ings on the inner and outer scissor arms. Use
multipurpose grease to lube the bottom bear-
ings in the channel at the bottom of the front
frame.
2.
Use a crane to lift the front frame. Align the
front frame with the outer scissor arms. Install
the pivot pins that retain the inner scissor arms
to the front frame.
3.
Install the brackets and hardware to retain the
pivot pins.
NOTE:
The reach carriage assembly must be in-
stalled on the mast before starting.
4.
After all hydraulic lines are connected, operate
the functions to check for leaks and correct op-
eration. Remove the air from the system and
adjust the stroke of the tilt cylinder as descri-
bed in Reach Assembly Adjustments.
5.
Install the forks and load backrest as removed.
See Forks and Load Backrest.
Single-Reach Scissor Arms
REMOVE AND DISASSEMBLE
NOTE:
The reach assembly must be in the fully-ex-
tended position.
The following procedures refer to removing the scis-
sor arms from the rear frame. See Figure 11.
Reach Assembly Front Frame 4500 SRM 1196
16