Hyster N30ZDR, Руководство пользователя

Страница: 14 / 28

3.
Lower the inner mast channels onto the load
rollers of the rear frame. If the inner mast does
not lower smoothly and completely, raise the
inner mast, reposition the reach carriage as-
sembly, and lower the inner mast again.
WARNING
Reach carriage assemblies are heavy. Be sure
that all lifting devices are suitable and of adequate
capacity to lift the components.
4.
Attach an overhead lifting device to the top of
the reach carriage assembly:
a.
Install heavy-duty, industrial C-clamps to
each side of the rear frame. See Figure 4.
b.
Install a chain loop or sling through each
clamp separately, and attach each loop to the
overhead lifting device.
5.
Raise the reach carriage assembly high enough
to access the hydraulic connections and wiring
harness mounting plate on the rear frame.
6.
Safety chain the reach carriage assembly in
place. See Safety Procedures When Working
Near Mast.
CAUTION
If reusing chains, make sure chains have been
properly inspected, cleaned, and lubricated. See
Lift Chains.
7.
Reconnect the lift chains to anchors on reach
carriage assembly as removed. Install anchor
pins and cotter pins.
8.
Connect the wiring connector and install the
mounting plate to the top of the rear frame.
9.
Remove caps/plugs from the attachment hoses
and fittings. Reconnect the hoses as removed.
10.
Remove the safety chains and completely lower
the reach carriage assembly.
11.
Remove the C-clamps and lifting device from
the reach carriage assembly.
12.
Raise and lower the mast several times to re-
move air from the system. Cycle the sideshift
function and the tilt function several times to
remove air from the circuit. Check for proper
operation.
13.
Check the hydraulic oil level and add as re-
quired.
14.
Check reach carriage assembly height and
alignment and adjust the lift chains as re-
quired. See Reach Assembly Adjustments.
15.
Install the load backrest. See Load Backrest.
16.
Install the forks. See Forks.
17.
Install the operator guard as removed.
Reach Carriage Assembly 4500 SRM 1196
8