1.
STUB SHAFT
2.
SPACER
3.
LH OUTER SCISSOR ARM
4.
BEARING ASSEMBLY
5.
BEARING RETAINER CAP
6.
BELLEVILLE WASHER
7.
CAPSCREW
Figure 12. Outer Arm and Bearing Assembly
NOTE:
Tag and identify each shim pack and the
load roller. When new load rollers are installed, the
shim arrangement will normally be the same or
similar.
WARNING
The points between the scissor arms and the rear
frame are pinch points and can cause an injury.
DO NOT put hands near pinch points when you
remove the pins. Use a hammer and brass drift to
remove the pivot pins.
7.
Models N35ZDR, N45ZR, N30ZDR, and
N35-40ZR have a position sensor mounted to
the right side inner scissor arm pivot pin at the
rear frame. Remove the position sensor as fol-
lows:
a.
Disconnect the wiring harness, carefully clip
the wire tie, and remove the capscrew and
spacer securing sensor bracket to the rear
frame. The sensor can now be turned, but the
sensor shaft should still be attached to the
pivot pin. See Figure 13.
1.
INNER SCISSOR ARM
2.
PIVOT PIN
3.
SETSCREW
4.
PIN RETAINER
5.
SCREW
6.
SENSOR SHAFT (FLAT TOWARD SETSCREW)
7.
POSITION SENSOR AND BRACKET
Figure 13. Position Sensor
4500 SRM 1196
Single-Reach Scissor Arms
19
Содержание N30ZDR
Страница 1: ...Hyster C264 N45ZR N35ZDR Forklift...
