Hypertherm XPR300, Инструкция по эксплуатации

Страница: 241 / 402

Maintenance
7
XPR300 Instruction Manual 809480 241
6. Clean and lubricate the torch if it does not need
replacement:
a. Use a clean, lint-free cloth to wipe the internal
and external surfaces. (See
Figure 52 .)
b. Use compressed air to remove debris from the
internal and external surfaces.

A cotton swab can be used for internal
surfaces that are difficult to reach. Do not
leave cotton fibers inside of the torch.
c. Apply a thin film of silicone lubricant (027055) to any O-ring that does not need
replacement and that looks dry.

The O-rings should look shiny. Too much lubricant can prevent gas flow.
Remove excess lubricant if found.
7. Before you supply power to the cutting system, install the following components:

Consumables in the torch. (See How to install the consumables on page 136.)

Torch in the torch receptacle. (See How to install the torch into the torch receptacle on
page 138.)
Examine the torch receptacle
1. Complete the following procedure before continuing:
a. Remove the power from the cutting system on page 234
2. Examine the torch receptacle. Look for:

Cuts, nicks, damage or excess
wear on the O-ring on the torch
receptacle

The O-ring on the torch
receptacle does not require
lubricant. The O-ring is for
dust protection only.

Cracks in the torch receptacle
body
3. Replace the O-ring if it has damage
or excess wear.

Torch rebuild kits are available from Hypertherm. (See Preventive
maintenance kits on page 369 of the Parts List .)
4. If you find cracks in the torch main body or torch insulator, replace the entire torch receptacle.
(See
Connect the EasyConnect torch lead assembly to the torch receptacle on page 128.)
Figure 52 – Wipe the internal and external
surfaces of the torch
The O-ring on the
torch receptacle