8
PRODUCT WATER FAUCET INSTALLATION - POLYMER FAUCET
Install on flat surface at least 2 7/16" in diameter. Unused 1 1/4"- 1 7/16" opening is ideal.
New Faucet Installation
Refer to Faucet Site Preparation, Page 5.
Replacement Faucet Installation
Verify size of existing hole. If hole measures 1 7/16",
faucet may be installed without changes. If hole
measures 1 1/4", remove two locator tabs (See Figure 8)
prior to installation by breaking them off at faucet base.
Figure 8
Faucet Locator Tabs.
NOTE:
Item callouts refer to Page 9, Figure 9 unless
otherwise
noted.
1. Remove mounting nut (Item 23) and bracket (Item 22)
from faucet.
2. Install 3/8" blue tube into blue collet in faucet base.
3.
Plain Front:
Insert tube into mounting hole and place
faucet over hole. Align faucet body with narrow face
forward.
Light Bar:
Insert tube and monitor cord into
mounting hole and place faucet over hole. Align
faucet body with light bar forward.
NOTE:
Do not pinch, kink, pull, or otherwise deform
monitor cord.
4. Install mounting bracket and nut below sink. Tighten
mounting nut
by hand
so that faucet does not move.
Do not over tighten.
NOTE:
Faucet is packaged for right-hand operation. For
left-hand operation, realign knob by completing
Step 5.
NOTE:
Item callouts in Step 5 refer to Page 9, Figure 9.
5. Align faucet knob for left-hand operation.
a. Rotate knob to rear of faucet (closed position).
b. Remove knob cover (Item 1) using a thin, flat tool
to pry cover from knob.
c. Remove knob attachment screw (Item 2) using a
Phillips-head screwdriver.
d. Remove knob (Item 3) by pulling it (by hand)
straight up. Rotate knob counterclockwise 90º,
and re-install.
e. Install knob attachment screw. Tighten screw
until free movement (i.e., rocking) is eliminated.
f. Snap knob cover into place.
6. Install spout into faucet body. Lubricate “O” ring with
FDA approved Silicone Lubricant. Align spout with
faucet outlet, gently push spout to bottom of outlet.
7. Connect 3/8" blue tubing to swivel elbow located on
rear of module.
8.
Light Bar:
Connect monitor cord to module. Insert
cord into a telephone-style connector located on
Filtration Module cover (See Page 6, Figure 6).
NOTE:
The basic installation is complete and system is
ready for activation (See Page 11).
CLEAN FAUCET SURFACE USING DISHWASHING DETERGENT ONLY. DO NOT USE ABRASIVES OR SOLVENTS.
