Hydro Smart 115 PLUS, Инструкция по установке и руководство пользователя

Страница: 21 / 49

21
NORMAL OPERATION
GENERAL (DHW)
• When the remote controller is installed, it will take priority over the built-in controller.
•
The controller has an energy saving mode. Five minutes after the water heater stops
operating, the backlig ht of the controller turns o ff .
• The backlight of the remote will turn back on once the boiler begins firing a gain.
1. Open a cold water
fi xture.
2. Mix hot water with the cold water
to get the correct temperature water.
3. When finis hed, close the
water fi xture.
temperature (1.9 L/min).
• Flow rate t o acti vate the boiler: 0.5 gallon per minute at the default set
NOTICE
• Flow rate to keep the boiler running: 0.4 gallon per minute (1.5 L/min).
BUILT-IN CONTROLLER and REMOTE CONTROLLER
from examples.
STAND BY LED (Orange)
"HOT" Bu tt on
"COLD" Button
Press the "HOT" bu tt on or the "COLD"
bu tt on to set the hot water temperature.
IN USE LED (Green)
The indicator is ON to show that
power is ON.
The indicator lights during combus tion.
"INFO" Button
Inlet water
Each time the bu tt on is pressed,
the opera tion mode is selected
in the sequence of the following.
temperature
Outlet water
temperature
Water
fl ow
Built-in controller
Display for Temperature
When the STAND BY LED is ON, the
hot water temperature will be
displayed.
"ON/OFF" Button
Remote controller
Press this bu tt on to
start or stop opera tion.
WARNING
Temperature above 125 °F (52 °C) can cause severe burns or death from scalding.
Children, disabled and the elderly are at high risk of being injured.
Built-In controller