Hydro Smart 115 PLUS, Инструкция по установке и руководство пользователя

Страница: 6 / 49

6
SAFETY GUIDELINES
SAFETY DEFINITION
Indicates informa tion considered important but not hazard related.
GENERAL
WARNING
CAUTION
Indicates an imminently hazardous situa tion which, if not avoided, could result
in death or serious injury.
Indicates an imminently hazardous situa tion which, if not avoided, could result
in minor or moderate injury.
DANGER
Indicates an imminently hazardous situa tion which, if not avoided, will result in
death or serious injury.
WARNING
cause severe injury or death.
NOTICE
• The conversion to propane must be done by a qualifie d service agent or a gas utility
serviceman in accordance with the gas conversion ins tructions and all codes and
requirements of the authority having jurisdiction. Failure to follow ins tructions could
result in serious injury or property damage. The qualifi ed agent performing this work
assumes responsibility for this conversion.
• Do not use this appliance if any part has been under water. Immediately contact a
qualified installer or service agency to replace a flooded boiler. Do not a tt empt
to repair the unit! It must be replaced!
• Do not disconnect the electrical supply if the ambient temperature will drop below
freezing. The Freeze Prot ection System only works if the unit has electrical power. The
warranty will not be covered if the heat exchanger is damaged due to freezing.
1. Follow all local codes, or in the absence of local codes, follow the current edition of the Na tional Fuel Gas Code:
ANSI Z223.1/NFPA 54 in the USA or B149.1 Natural Gas and Propane Installa tion code in Canada.
2. Properly ground the unit in accordance with all local codes, or in the absence of local codes, with the current
edition of the Na tional Electrical Code: ANSI/NFPA 70 in the USA or CSA standard C22.1 Canadian Electrical
Code Part 1 in Canada.
3. Carefully plan where you intend to install the boiler. Please ensure:
• Your boiler will have enough combus tion air and proper ven til a tion.
• Locate your boiler where water leakage will not damage surrounding areas.
4. Check the ra ting plate for the correct GAS TYPE, GAS PRESSURE, WATER PRESSURE and ELECTRIC RATING . If this
unit does not match your requirements, do not install and consult with the manufacturer . The boiler is
con figu red only for use with Natural Gas at the factory. If the appliance is used with propane gas, conversion to
propane gas with an included conversion kit (LP Conversion Kit) is required. The conversion must
be done by a qualified service agent or a gas utility serviceman in accordance with this ins truction and all codes
and requirements of the authority having jurisdiction. Failure to follow ins tructions could result in serious injury
or property damage. The agent performing this work assumes responsibility for this conversion. (Refer to the
gas conversion lea fl et.)
5. If any problem should occur, turn o ff all hot water fi xtures and turn o ff the gas. Then call a trained technician
or the Gas Company or the manufacturer.
• Water temperatures over 125 °F (52 °C) can cause severe burns instantly or death from
scalding. The water temperature is set at 120 °F (50 °C) from the factory to minimize any
scalding risk. Before bathing or showering, always check the water temperature.
• Do not store or use gasoline or other fla mmables, vapors, or liquids in the vicinity of this appliance.
• Do not reverse the water and/or gas connec tions as this will damage the gas valves and can
DHW Use