3-4
D
RIp
p
IpIng
anD
s
plashguaRDs
P/N 0501930_G
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • www.hussmann.com
3 . Position splashguard bottom slot
over the splashguard retainer on each
end of the merchandiser, and align the
screw slots with the hold in the upper
support . Fasten the splashguard to the
upper support with self-drilling screws .
4 . Seal the splashguard to the floor
using silicone sealant .
If silicone will not fill gaps caused by
uneven floor, field-supplied cove trim
should be used .
To install the cove trim to the splashguard:
1 . Remove all dirt, wax and grease
from the area of the splashguard where
adhesion will be necessary to ensure a
secure installation .
2 . Apply a good contact cement to the
cove trim and allow proper drying time
according to the directions supplied with
the cement .
3 . Install the trim to the splashguard so
that it is lying flush with the floor .
d
o
noT
seal
The
Trim
To
The
floor
.
4.
If required by local health codes
the
Cove Trim may be sealed to the floor,
using a silicone type sealer . Sealant must
be removed and replaced when servicing .
Upper Splashguard Retainer Slots
Position Splashguard
Over Splashguard Retainers
3.
Splashguard Installed
4.
Splashguard
Cement
Cove Trim
