P/N 0501930_G
1-9
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
Ultra Low Front
Rear Load
Excel
Seal Merchandisers
1 . Remove interior front panel and interior
panel support bracket to apply butyl tape .
(Display pans were removed in earlier step .)
2 . Apply butyl tape across the end shoe
joint . Be sure to extend the tape up the back
and front of the merchandiser .
Silicone sealer may be applied around joining
bolts on both sides in bottom shoe but isn’t
necessary if neoprene washers are used .
INSTALL SPLASHGUARD BRACKETS
Position splashguard brackets at the front
of the merchandiser, on the floor, at 4 foot
intervals . Each bracket has a
3
/
8
in . (10 mm)
slot at the rear of the bracket to allow
some adjustment where it attaches to the
merchandiser . Use a driver extension to
tighten screws that secure the brackets .
Once drip piping is complete, install
splashguards as described in Section 3 .
Butyl Tape
Install splashguard brackets
before installing drip piping.
CAUTION
WARNING
ADVERTENCIA
PRECAUCIÓN
Display
Pan
Interior Front Panel
Front, looking down
Interior Panel Support
Bracket
Bring butyl
tape up to this
point.
