1-10
I
nstallatIon
P/N 0501930_G
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • www.hussmann.com
OFFSETTING BUMPER
Offsetting the bumper helps to disguise the
joint locations, giving the lineup a smoother
look .
1 . Locate starter bumper shipped with the
left-end kit .
2 . Remove factory installed bumper by
pulling bumper away from bumper retainer .
Be careful not to lose the internal joint trim on
the bumper .
3 . If not installed, install bumper end caps as
shown .
4 .
Starting at the left end of the line up, install
the bumper starter section first . To install,
a . Position internal joint trims so that
the first is flush to the left-end panel and
the second is centered between the starter
bumper and the full length bumper as
shown .
b . Install full length bumpers and internal
trims offset across joints . Make sure that
no gaps exist between sections . Continue
installing the bumpers the length of line up .
5 . Once all except the last section of bumper
have been installed refrigerate the merchan-
diser line up for at least six (6) hours .
The last
section of bumper should be kept inside a cooler
or refrigerated merchandiser during this time.
This will allow the bumper to contract .
6 . Go to the right end of the line up and tap
the bumper to close any gaps .
7 .
Measure and cut last sections of bumper .
Use a miter box and fine-tooth saw to cut last
bumper to length . Install the last section .
Merchandiser
Joint
Starter
Bumper
Retainer
Full Length
Bumper
Internal Joint Trims
Bumper
Miter Box
Bumper Retainer
Bumper End Cap
Screws
