OPERATION
22
Problem
The shading limits need to be adjusted.
Solution
Adjust the Upper Limit.
NOTE:
Programming mode timeout is 20 seconds. If there is no action within 20
seconds, programming mode exits.
■
Move the shading to the fully open position (shading is completely inside the
headrail). See “Basic Operation” on page 17.
■
Programming Mode — In two motions: push the wand up and release,
and quickly push the wand up and hold. After approximately 6 seconds
the shading will beep and a red LED behind the activator arm will blink
continuously to indicate programming mode.
■
Release the wand. The upper limit is ready to be adjusted.
■
Pull the wand down and release to move the shading down. When the
desired upper limit location is reached, stop the shading. Push the wand up
and hold for approximately 6 seconds until the shading moves slightly twice
(down, up). The red LED turns off.
■
Release the wand. The shading movement indicates the new upper limit is
set and the shading exits programming mode.
(continued on next page)
