INSTALLATION
13
STEP 4: Connect the Power Source, If Applicable
■
If you have attached the battery wand in step 2, proceed to “Unpack the Wand and Attach to
Activation Arm” on page 15.
NOTE:
When power is connected to the motor, a green LED inside the control side end cap will
flash to indicate the shading is ready for operation.
■
Refer to the appropriate page based on your order.
➤
For an optional satellite battery pack, see below.
➤
For an optional 18V DC power supply, see page 14.
➤
For an optional 18V DC power supply with daisy-chain connections, see page 15.
➤
For an optional C-size satellite battery wand or large DC power supply, see the
instructions that came with the unit.
Satellite Battery Pack
Mount the Satellite Battery Pack
■
Decide where you want to mount the satellite battery pack. A satellite battery pack may be
mounted in any orientation.
■
Mark the screw holes for the wall mount bracket.
■
Drill the screw holes using a
3
/
32
" drill bit.
■
Remove the backing from the double-sided tape. Press the
bracket into place.
■
Attach the bracket using the screws provided.
■
Position the battery wand so the power cable is easily connected to the socket.
■
Snap the battery wand into the wall mount bracket.
■
Install the cover with the slot aligned to the socket in the battery wand.
Wall Mount Bracket
Socket
Battery Wand Cover
Slot
Socket
