INSTALLATION
11
STEP 3 — Install the Shading
Install the Optional Back Cover (If Applicable)
The optional back cover is used on inside mounts only.
■
Install the back cover into the back cover brackets on the rear of the installation brackets, as
shown. If necessary, trim the back cover to the desired width.
➤
On shadings with battery wand(s), the top of the back cover fits onto the top tab of the
back cover bracket.
IMPORTANT:
If using a battery wand, do not install the optional back cover until
the battery wand is installed (see Battery Wand on page 10).
➤
On all other shadings, the top tab has been removed and installs closer to the
installation bracket.
Mount the Headrail
■
Peel back the protective covering from the top of the fabric-covered headrail. Leave the rest
of the protective covering on the front of the headrail.
■
Position the shading so that the front faces you.
■
Slide the headrail into the installation brackets so the edge of the headrail is between the
lever and the bracket, as shown.
■
Firmly push the headrail into each
bracket until it clicks and the lever
snaps to the right side of the bracket.
IMPORTANT:
Carefully pull on the
headrail at each bracket to ensure it
is installed securely.
■
Completely remove the protective
covering from the fabric-covered headrail.
Headrail
Installation
Bracket
Lever
Slide the Headrail
Between the Lever
and the Bracket
Back
Cover
Back
Cover
