Huber Unichiller 400T, Руководство по эксплуатации

Страница: 58 / 86

Setup mode
OPERATION MANUAL Chapter 4
Unichiller®
V2.3.0en/07.06.19//17.12
58

Enter the new “KP” value using the number keypad that appears.

Confirm your entry by tapping on “OK”.

Enter the new “Tn” value using the number keypad that appears.

Confirm your entry by tapping on “OK”.

Enter the new “Tv” value using the number keypad that appears.

Confirm your entry by tapping on “OK”.
4.2.9.1.2 Sub-category: “Jacket”
Enter the new value for “KP” here.
PROCEDURE

Go to the “Categories Menu”.

Tap on the category “Temperature Control”.

Tap on the category “TAC/Manual”.

Tap on the sub-category “Configuration manual”.

Tap on the sub-category “Change parameters”.

Tap on the sub-category “Jacket”.

Enter the new “KP” value using the number keypad that appears.

Confirm your entry by tapping on “OK”.

Read the message and confirm it by tapping on “OK”.
4.2.9.1.3 Sub-category: “Process”
Enter the new values for “KP”, “Tn” and “Tv” here one after the other.
PROCEDURE

Go to the “Categories Menu”.

Tap on the category “Temperature Control”.

Tap on the category “TAC/Manual”.

Tap on the sub-category “Configuration manual”.

Tap on the sub-category “Change parameters”.

Tap on the sub-category “Process”.

Enter the new “KP” value using the number keypad that appears.

Confirm your entry by tapping on “OK”.

Enter the new “Tn” value using the number keypad that appears.

Confirm your entry by tapping on “OK”.

Enter the new “Tv” value using the number keypad that appears.

Confirm your entry by tapping on “OK”.
4.2.9.2 Sub-category: “Display parameters”
In this function, the set manual parameters are displayed.
PROCEDURE

Go to the “Categories Menu”.

Tap on the category “Temperature Control”.

Tap on the category “TAC/Manual”.

Tap on the sub-category “Configuration manual”.

Tap on the sub-category “Display parameters”.

Tap on “OK” after you have read/checked the parameters.
4.2.9.3 Sub-category: “Control structure”
With this function, you have two different control structures available.
“Huber PID controller”: Default setting
“Classic PID controller”: This setting is exclusively used by Huber service engineers for service pur-
poses.