Huber Unichiller 400T, Руководство по эксплуатации

Страница: 46 / 86

Setup mode
OPERATION MANUAL Chapter 4
Unichiller®
V2.3.0en/07.06.19//17.12
46
4 Setup mode
4.1 Setup mode
Moving the temperature control unit during operation
SERIOUS BURNS/FREEZING OF THE HOUSING PARTS/ESCAPING THERMAL FLUID
 Do not move temperature control units that are in operation.
4.1.1 Emergency stop switch (optional): Activate / Deactivate
By activating the >Emergency stop switch< [70], all poles of the temperature control unit are
disconnected immediately .
4.1.1.1 Emergency stop switch (optional): Activate
PROCEDURE

Press the >Emergency stop switch< [70].
All poles of the temperature control unit are disconnected immediately .
4.1.1.2 Emergency stop switch (optional): Deactivate
PROCEDURE

Turn the >Mains isolator< [36] to the “0” position!

Release the >Emergency stop switch< [70] by turning it clockwise. A built-in spring in the >Emer-
gency stop switch< [70] returns it to its original state.
4.1.2 Turning on the temperature control unit
PROCEDURE

Switch on the temperature control unit using the >Mains isolator< [36].
Only valid for temperature control units with an emergency stop switch (optional):
The safety relay is tested. Press the illuminated >Release button< [0]. The temperature control
unit is started and the illumination in the >Release button< [0] is turned off.
Then a system test is conducted to test the full functionality of the temperature control unit. All
sensors, the all-pole disconnecting power disconnect relay for the power supply and the power
electronics of the main heater and the main heater itself are checked. A message appears on the
>Touchscreen< [88] in case of an error or if a warning is issued. Contact Customer Support if in
doubt (the phone number can be found on page 84 in Section »Contact data« ).
Exemplary layout of
the switches