Huber Unichiller 400T, Руководство по эксплуатации

Страница: 57 / 86

Setup mode
Chapter 4 OPERATION MANUAL
V2.3.0en/07.06.19//17.12
Unichiller®
57
4.2.8.3.4 Sub-category: “Show Fluid”
This entry provides you with an overview of the settings entered.
PROCEDURE

Go to the “Categories Menu”.

Tap on the category “Temperature Control”.

Tap on the category “TAC/Manual”.

Tap on the sub-category “Configuration auto”.

Tap on the sub-category “Fluid Properties”.

Tap on the sub-category “Show Fluid”.

Tap on “OK” after you have read/checked the entries.
4.2.8.4 Sub-category: “Display parameters”
Here you can display the set parameters in “Automatic mode”.
PROCEDURE

Go to the “Categories Menu”.

Tap on the category “Temperature Control”.

Tap on the category “TAC/Manual”.

Tap on the sub-category “Configuration auto”.

Tap on the sub-category “Display parameters”.

Tap on “OK” after you have read/checked the parameters.
4.2.9 Sub-category: “Configuration manual”
Use of the “Expert mode” without a thorough knowledge of I&C technology.
MATERIAL DAMAGE TO THE APPLICATION

Only use this mode if you have a thorough knowledge of I&C technology.
In “Expert mode”, “Configuration auto” is deactivated only “Configuration manual” is possible.
To enter settings in “Expert mode” requires in-depth knowledge of process measuring and control
technology. Incorrect or insufficient settings can severely impair the function of the temperature
control unit.
4.2.9.1 Sub-category: “Change parameters”
In this menu you manually configure the control parameters. If only the internal temperature is used
as a target value, the control parameters are entered only under “Internal”. If the process tempera-
ture is used as the target value, also the internal controller can be used, for example, when reaching
the set point limit or in case of a Delta T limit. Consequently, parameter sets must be entered under
all three items (“Internal”, “Jacket” and “Process”) when using the process temperature as a target
value.
4.2.9.1.1 Sub-category: “Internal”
Enter the new values for “KP”, “Tn” and “Tv” here one after the other.
PROCEDURE

Go to the “Categories Menu”.

Tap on the category “Temperature Control”.

Tap on the category “TAC/Manual”.

Tap on the sub-category “Configuration manual”.

Tap on the sub-category “Change parameters”.

Tap on the sub-category “Internal”.