UPS2000-G-(1 kVA-3 kVA)
User Manual
4 Setting Control Panel
Issue 08 (2017-08-04)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
29
The user interface (UI) snapshots in this document are taken from the software version
UPS2000V200R001C01SPC300 (V2R1C1SPC30 is displayed on the NetEco; you can query
the version information by choosing
Maintenance
>
Current Version
). The UI snapshots are
subject to change without notice. Contact Huawei technical support to obtain the latest
snapshots if necessary.
There are seventeen configurable parameters on the LCD. The following figures show the
parameter setting screens.
Figure 4-3
Setting parameters on the LCD
When the UPS is in standby mode or bypass mode, hold down
SELECT
for 5 seconds to start
setting UPS parameters.
When the UPS is in normal mode or battery mode, hold down
SELECT
for 5 seconds to
enable or disable the buzzer off (BUZ) function, set the DHCP (DHP) function, or view the IP
address (IP), subnet mask (SUB), and gateway (GAT).
During the setting of UPS parameters, press
ON/MUTE
for more than 3 seconds. Release the
button when you hear a beep sound to select the previous option. During the setting of UPS
parameters, press
SELECT
for more than 3 seconds. Release the button when you hear a
beep sound to select the next option. Press
OFF/ENTER
for more than 3 seconds to confirm
the setting.
The following figures show the seventeen parameter setting screens.
Set the output voltage.
Display
Setting
