2.
Run:
rip
[
process-id
]
The RIP process is enabled and the RIP view is displayed.
3.
Run:
version
2
RIP-2 is configured.
4.
Run:
summary
[
always
]
–
Enable the RIP-2 automatic route summarization when split horizon is disabled,
there is no need to configure
always
.
–
Enable the RIP-2 automatic route summarization irrespective of split horizon
configuration,
always
must be configured.
NOTE
The
summary
command is used in the RIP view to enable classful network-based route
summarization.
l
Configuring RIP-2 to Advertise the Summary Address
1.
Run:
system-view
The system view is displayed.
2.
Run:
interface
interface-type
interface-number
The interface view is displayed.
The interface must be a VLANIF interface.
3.
Run:
rip summary-address
ip-address
mask
[
avoid-feedback
]
The local summary address of RIP-2 is advertised.
NOTE
The
rip summary-address
ip-address
mask
[
avoid-feedback
] command is run in the
interface view to enable classless network-based route summarization.
----End
2.7.3 Configuring Packet Authentication of RIP-2
RIP-2 supports the ability to authenticate protocol packets and provides two authentication
modes, Simple authentication and Message Digest 5 (MD5) authentication, to enhance security.
Context
RIP-2 supports two authentication modes:
l
Simple authentication
l
MD5 authentication
In simple authentication mode, the unencrypted authentication key is sent in every RIP-2 packet.
Therefore, simple authentication does not guarantee security, and cannot meet the requirements
for high security.
S6700 Series Ethernet Switches
Configuration Guide - IP Routing
2 RIP Configuration
Issue 01 (2012-03-15)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
41
