HPE ProLiant ML350, Руководство по техническому обслуживанию и ремонту

Страница: 28 / 124

Rack warnings
WARNING:
To reduce the risk of personal injury or damage to the equipment, be sure that:
• The leveling jacks are extended to the floor.
• The full weight of the rack rests on the leveling jacks.
• The stabilizing feet are attached to the rack if it is a single-rack installation.
• The racks are coupled together in multiple-rack installations.
• Only one component is extended at a time. A rack may become unstable if more than one
component is extended for any reason.
WARNING:
To reduce the risk of personal injury or equipment damage when unloading a rack:
• At least two people are needed to safely unload the rack from the pallet. An empty 42U rack can
weigh as much as 115 kg (253 lb), can stand more than 2.1 m (7 ft) tall, and might become unstable
when being moved on its casters.
• Never stand in front of the rack when it is rolling down the ramp from the pallet. Always handle the
rack from both sides.
WARNING:
To reduce the risk of personal injury or damage to the equipment, adequately stabilize the rack before
extending a component outside the rack. Extend only one component at a time. A rack may become
unstable if more than one component is extended.
WARNING:
When installing a server in a telco rack, be sure that the rack frame is adequately secured at the top and
bottom to the building structure.
Preparation procedures
To access some components and perform certain service procedures, perform one or more of the following
procedures:
• Power down the server .
If you must remove a server from a rack or a non-hot-plug component from a server, power down the
server.
• Extend the server from the rack .
If you are performing service procedures in a Hewlett Packard Enterprise, Compaq branded, Telco, or
third-party rack cabinet, you can use the locking feature of the rack rails to support the server and gain
access to internal components.
For more information about telco rack solutions, see the RackSolutions.com website .
• Remove the bezel:
◦ Remove the tower bezel .
◦ Remove the security bezel .
• Remove the server from the rack .
If the rack environment, cabling configuration, or the server location in the rack creates awkward
conditions, remove the server from the rack.
• Remove the air baffle .
28 Rack warnings