HPE ProLiant ML350, Руководство по техническому обслуживанию и ремонту

Страница: 50 / 124

7. Install the air baffle.
8. Install the access panel.
9. Do one of the following:
• If the server is in a tower configuration, return the server to an upright position.
• If the server is in a rack configuration, slide the server into the rack.
10. Connect each power cord to the server .
11. Connect each power cord to the power source.
12. Power up the server .
13. Do one of the following:
• For tower models, install the tower bezel.
• For rack models, install the security bezel.
DIMMs
IMPORTANT:
This server does not support mixing LRDIMMs and RDIMMs. Attempting to mix any combination of
these DIMMs can cause the server to halt during BIOS initialization.
To identify the DIMM s installed in the server , see " DIMM slots ."
1. Do one of the following:
• For tower models, open and remove the tower bezel .
• For rack models, if installed, remove the security bezel .
2. Power down the server .
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server .
4. Do one of the following:
a. For tower models, place the server on a flat, level surface with the access panel facing up.
b. For rack models, extend the server from the rack .
5. Remove the access panel .
6. Remove the air baffle .
7. Remove the DIMM.
50 DIMMs