HPE ProLiant ML350, Руководство по техническому обслуживанию и ремонту

Страница: 31 / 124

6. After completing the maintenance procedure, slide the server back into the rack, and then press the server
firmly into the rack to secure it in place.
WARNING:
To reduce the risk of personal injury, be careful when pressing the server rail-release latches and
sliding the server into the rack. The sliding rails could pinch your fingers.
Remove the server from the rack
WARNING:
This server is heavy. To reduce the risk of personal injury or damage to the equipment:
• Observe local occupational health and safety requirements and guidelines for manual material handling.
• Get help to lift and stabilize the product during installation or removal, especially when the product is not
fastened to the rails. Hewlett Packard Enterprise recommends that a minimum of two people are required
for all rack server installations. A third person may be required to help align the server if the server is
installed higher than chest level.
• Use caution when installing the server in or removing the server from the rack; it is unstable when not
fastened to the rails.
IMPORTANT:
The requirement of extending or removing the server from the rack when performing installation and
maintenance procedures depends on the rail system used:
• If using a ball-bearing rail system, you can perform most installations and maintenance by simply
extending the server from the rack.
• If using a friction rail system, to perform installations or maintenance that requires access panel removal,
remove the server from the rack.
To remove the server from a Hewlett Packard Enterprise, Compaq-branded, Telco, or a third-party enclosure :
Procedure
1. Remove the security bezel .
2. Power down the server .
3. Disconnect all peripheral cables and power cords from the server rear panel.
4. Extend the server from the rack .
Remove the server from the rack 31