HPE ProLiant ML30 Gen10, Руководство пользователя

Страница: 68 / 142

14. If removed, install the air baffle.
15. Install the access panel.
16. Install the front bezel.
17. Do one of the following:
• If the server is in tower mode:
Position the tower server for operation.
• If the server is in rack mode: Install the server on the tray.
18. Connect all peripheral cables to the server.
19. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
20. Power up the server.
The installation is complete.
To configure arrays, see the HPE Smart Array SR Gen10 Configuration Guide at the
Hewlett Packard Enterprise
website.
Memory options
IMPORTANT: This server does not support mixing RDIMMs and UDIMMs. Attempting to mix any combination of
these DIMMs can cause the server to halt during BIOS initialization. All memory installed in the server must be of
the same type.
DIMM population information
For specific DIMM population information, see the DIMM population guidelines on the Hewlett Packard Enterprise website
(
http://www.hpe.com/docs/standard-population-rules).
Installing a DIMM
Procedure
1. Power down the server.
2.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
68
Hardware options installation