HPE ProLiant ML30 Gen10, Руководство пользователя

Страница: 77 / 142

Procedure
1. During the server startup sequence after installing the module, press F9 in the POST screen.
The System Utilities screen appears.
2. Select System Configuration | iLO 5 Configuration Utility.
The iLO 5 Configuration Utility screen appears.
3. Select Network Options, and then press Enter.
The Network Options screen appears.
4. Set the Network Interface Adapter field to ON, and then press Enter.
5. Press F10 to save your changes.
A message prompt to confirm that the iLO settings reset appears.
6. Press Enter to reboot the iLO settings.
7. Press Esc until the main menu is displayed.
8. Select Reboot the System to exit the utility and resume the boot process.
The IP address of the enabled dedicated iLO connector appears on the POST screen on the subsequent boot-up.
Access the Network Options screen again to view this IP address for later reference.
M.2 SSD option
Use the M.2 slot on the system board or on the optional M.2 SSD/dedicated iLO/serial port enablement board to install an
M.2 SSD on the server.
The S100i SR Gen10 SW RAID support requires that the server boot mode be set to UEFI.
Installing an M.2 NVMe SSD on the system board
Prerequisites
Before you perform this procedure, make sure that you have the following tools available:
• T-15 Torx screwdriver
• 4.5 mm hex nut screwdriver
• Phillips No. 1 screwdriver
Procedure
1. Power down the server.
2.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
Hardware options installation
77