switch(vlan-29-pim-dense)# exit
switch(vlan-29)# exit
Figure 10: Multicast routing configuration on switch #1 in Multicast network with a multinetted VLAN
Switch(config)# show run
...
ip routing
ip multicast-routing
...
vlan 29
name "VLAN29"
untagged A11-A15,A17
ip address 10.29.30.1 255.255.255.0
ip igmp
exit
vlan 25
name "VLAN25"
untagged A20-A24
ip address 10.38.10.1 255.255.255.0
ip address 10.38.11.1 255.255.255.0
ip address 10.38.12.1 255.255.255.0
ip igmp
exit
vlan 27
name "VLAN27"
untagged A6-A10,A18
ip address 10.27.30.1 255.255.255.0
ip igmp
exit
router rip
enable
exit
t
enable
rou er pim
state-refresh 45
trap hardware-mrt-full
exit
vlan 25
vlan 27
ip rip 10.38.10.1
ip rip 10.38.11.1
ip pim-dense
ip-addr 10.38.10.1
exit
Note:
Dashed lines indicate configuration
settings affecting multicast routing.
Multinetting and IGMP enabled in VLAN 25.
Multicast Routing Configuration for Global Level..
Enables IP routing; required for multicast routing.
Indicates the source-IP-address for multicast packets
forwarded on this VLAN.
Multicast Routing Configuration for VLAN 25.
Multicast Routing Configurations
for VLANs 27 and VLANs 29
untagged <port>
ip address <ip address> <subnet mask>
ip rip <ip address>
ip pim-dense
ip-addr any
exit
vlan 29
untagged <port>
ip address <ip address> <subnet mask>
ip rip <ip address>
ip pim-dense
ip-addr any
exit
Displaying PIM data and configuration settings
Displaying PIM route data
Syntax:
show ip [mroute]
Without parameters, lists multicast route entries in the following situations:
Chapter 3 PIM-DM (Dense Mode)
61
