Reinstalling and replacing the speaker
To reinstall or replace the power button assembly, reverse the previous removal steps.
Optical drive
This section describes how to remove and install an optical disk drive in a minitower workstation
configuration.
Removing an optical drive
1.
Disconnect power from the system (see
Predisassembly procedures on page 52
).
2.
Remove the side access panel (see
Side access panel on page 58
).
CAUTION:
To prevent damage to the workstation, observe the following Electrostatic Discharge
(ESD) precautions while performing the system parts removal and replacement procedures:
— Work on a static-free mat.
— Wear a static strap to ensure that any accumulated electrostatic charge is discharged from your
body to the ground.
— Create a common ground for the equipment you are working on by connecting the static-free
mat, static strap, and peripheral units to that piece of equipment.
3.
Remove the front bezel (see
Removing the front bezel on page 61
).
4.
Disconnect the power (1) and data (2) cables from the optical drive, as shown:
Figure 4-17
Disconnecting the optical drive cables
ENWW
Removing and replacing components
67
Содержание Xw6600 - Workstation - 2 GB RAM
