HP Xw6200 - Workstation - 2 GB RAM, Техническое справочное руководство

Страница: 144 / 209

144
SYSTEM DIAGNOSTICS AND TROUBLESHOOTING
162—System Options Not Set Configuration incorrect. RTC battery
might need to be replaced. 1 Run Computer Setup (F10 Setup).
2 Set the date and time under Control Panel or in
F10 Setup depending on the operating system.
3 If the problem persists, replace the RTC battery.
163—Time and Date Not Set Invalid time or date in configuration
memory.
RTC (real-time clock) battery might
need to be replaced.
CMOS jumper might not be properly
installed. 1 Set the date and time under Control Panel or in
F10 Setup depending on the operating system.
2 If the problem persists, replace the RTC battery.
164—Memory Size Error Memory configuration is incorrect. 1 Run Computer Setup (F10 Setup) or Windows
utilities.
2 Be sure memory module(s) (if any) are installed
properly.
3 If third-party memory has been added, test using
HP-only memory.
4 Verify proper memory module type.
183—Invalid Processor
Jumper Setting System board jumper improperly set. Reset system board jumpers to match processor and
bus speeds (select models).
201—Memory Error RAM failure. 1 Run Computer Setup (F10 Setup) or Windows
utilities.
2 Be sure that memory and continuity modules are
installed correctly.
3 Verify proper memory module type.
4 Remove and replace memory module(s) one at a
time to isolate faulty module.
5 Replace the faulty memory module(s).
6 If error persists after replacing memory modules,
replace the system board.
202—Memory Type Mismatch Memory modules do not match each
other. Replace memory modules with matched sets.
207—ECC Corrected Single
Bit Errors in Memory Socket(s)
y,y Single Bit ECC error. 1 Verify proper memory module type.
2 Try another memory socket.
3 Replace memory module if problem persists.
212—Failed Processor Processor has failed to initialize. 1 Reseat the processor in its socket.
2 If the processor does not respond, replace it.
213—Incompatible memory
Module in memory Socket(s)
X,X, X A memory module in memory socket
identified in the error message is
missing critical SPD information, or is
incompatible with the chipset. 1 Verify proper memory module type.
2 Try another memory socket.
3 Replace memory with a module conforming to the
SPD standard.
Table 5-18 POST Error Messages (Continued)
Screen Message Probable Cause Recommended Action