HP X5000 G2, Руководство администратора

Страница: 87 / 179

Removing and replacing the front bezel (full)
NOTE: This full procedure is only required if all screws are not accessible due to the position of
the system in the rack.
Removing the front bezel (full)
1. Power off the system as described in “Powering the storage system off and on” (page 60) .
2. Remove the enclosure from the rack as described in “Removing the system enclosure from the
rack” (page 67) .
3. Pull the hard drive handle down 90 degrees, and slide out the hard drive drawer.
4. Remove all eight screws from the front bezel and pull the handle down 90 degrees (1, Figure 80
(page 87) ). Then lift the front bezel up and out to remove the front bezel (2).
NOTE: There are two screws on the bottom, four screws on the sides (two on each side),
and two screws hidden behind the handle.
Figure 80 Removing the front bezel
Removing and replacing the front bezel (full) 87