Installing and Configuring the Director 2/64
61
Director 2/64 Installation Guide
6. Position the rail tray, as shown in
Figure 19
and insert the tray into the rack
from the front.
Note:
Make sure the slots in the sides of the rail tray slide over the posts on the rear rail
tray brackets, and the posts on the rail tray’s front mounting flanges are inserted into
the center holes of U1.
Figure 19: Inserting the rail tray in the rack
7. Secure the rail tray:
a.
Insert an M5 Torx screw through the top holes in both of the rail tray
mounting flanges. The screws pass through the holes in the rack uprights
and thread into the Tinnerman nuts installed on the rack uprights in
step 5
.
b.
Tighten both M5 Torx screws.
