Installing and Configuring the Director 2/64
57
Director 2/64 Installation Guide
9. Connect the equipment rack power cords to separate (for redundancy) facility
power sources, providing single-phase, 120 to 240 VAC current.
Figure 14: AC power connections
HP System/e and Industry-Standard 19-in Rack Installation
To install the director in a HP system/e or industry-standard 19-in rack, complete
the procedures in the following sections:
■
Install the Anti-tip Feet on a HP System/e Rack
, page 57
■
Install Mounting Bracket Hardware in the Rack
, page 58
■
Prepare the Front and Rear Rack Columns
, page 62
■
Prepare the Switch for Installation
, page 63
■
Finalize the Rack Mounting Procedure
, page 65
■
Sliding Shelf Installation—For an HAFM Server only
, page 67
■
Recommended Cable Management
, page 70
Install the Anti-tip Feet on a HP System/e Rack
Use the following procedure to mount anti-tip feet on a HP system/e rack only, as
shown in
Figure 15
:
1. Place the anti-tip feet (
1
), provided in the HP system/e and industry-standard
19-in rack mount kits on the front and rear of the rack base.
2. Secure the anti-tip feet (
1
) to the base of the rack (front and rear).