Removal and replacement procedures 37
b.
Disconnect each power cord from the server.
3.
If the server is using a DC power supply:
a.
Remove the safety cover.
b.
Remove the power ring tongues from the terminal block.
c.
Remove the ground (earthed) wire.
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the power supply or
power supply blank to cool before touching it.
4.
Remove the power supply.
To replace the component, reverse the removal procedure.
Access panel
To remove the component:
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION:
Do not operate the server for long periods with the access panel open or removed.
Operating the server in this manner results in improper airflow and improper cooling that can
lead to thermal damage.
1.
Power down the server (on page
31
).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Do one of the following:
o
Extend the server from the rack (on page
32
).
o
Remove the server from the rack (on page
34
).
4.
Open the access panel latch, slide the access panel to the rear of the chassis, and then remove the
access panel.
If the access panel latch is locked, use a T-15 Torx screwdriver to unlock the latch.
Содержание ProLiant DL380e Gen8
