HP ProLiant DL380 G5 DPSS, Руководство администратора

Страница: 127 / 168

Shared disk requirements
NOTE:
Do not let more than one node access the shared storage devices at the same time until Cluster service
is installed on at least one node and that node is online. This can be accomplished through selective
storage presentation, SAN switch zoning, or having only one node online at all times.
• All software components listed in the HP ProLiant Storage Server SAN Connection and
Management white paper (located on the server documentation CD) must be installed and the
fi ber cables attached to the HBAs before the cluster installation is started.
• All shared disks, including the quorum disk, must be accessible from all nodes.
• All shared disks must be con fi gured as basic (not dynamic).
• All partitions on the disks must be formatted as NTFS.
Cluster installation
During the installation process, nodes are shut down and rebooted. These steps guarantee that the data
on disks that are attached to the shared storage bus is not lost or corrupted. This can happen when
multiple nodes try to simultaneously write to the same disk that is not yet protected by the cluster software.
Use
Table 17 to determine which nodes and storage devices should be presented during each step.
Table 17 Power sequencing for cluster installation
Step
Node 1 Additional
Nodes
Storage Comments
Setting up
networks
On On Not
Presented
Verify that all storage devices on the
shared bus are not presented; Power
on all nodes.
Setting up
shared disks
On
Off Presented Shut down all nodes. Present the shared
storage, then power on the fi rst node.
Verifying disk
con fi guration
Off
On
Presented Shut down fi rst node, power on next
node. Repeat this process for all cluster
nodes.
Con fi guring the
fi rst node
On
Off Presented Shut down all nodes; power on the fi rst
node.
Con fi guring
additional
nodes
On On Presented
Power on the next node after the
fi rst node is successfully con fi gured.
Complete this process for all cluster
nodes.
Post-installation On On Presented At this point all cluster nodes should be
on.
To con fi gure the Cluster service on the storage server, an account must have administrative permissions
on each node. All nodes must be member servers within the same domain. It is not acceptable to have a
mix of domain controllers and member servers in a cluster.
Setting up networks
Each cluster node requires at least two network adapters—one to connect to a public network, and one
to connect to a private network consisting of cluster nodes only.
HP ProLiant DL380 G5 Storage Server 127