HP ProLiant DL180se G6 Server, Руководство по техническому обслуживанию и ремонту

Страница: 138 / 147

Diagnostic tools and setup utilities 138
POST error descriptions
When a non-fatal error occurs during POST, the screen will display an error message with the format
“xxx-Error Identifier String” where “xxx” is a unique number code that matches ODM system specific
error documentation and may be a hexadecimal or decimal value.
All Error messages describe the problems as shown below:
Table 29
POST Error Messages
Error code Description
601 Error: BMC Not Responding
605 BMC Has Detected Fatal Hardware Error
611 Internal User Area Of BMC FRU Corrupted
612 Controller Update 'boot block' Firmware Corrupted
613 Controller Operational Firmware Corrupted
624 Power Supply Failure or Power Supply Unplugged
628 Redundant Power Supply Mismatch
622 Either Fan Failure or Fan Missing
194 CPUID, Processor family are different
192 L3 cache size mismatch
197 Processor speeds mismatched
005 CMOS Checksum Bad
041 Display memory test failed
040 Refresh timer test failed
048 Password check failed
003 CMOS Battery Low
701
Insufficient Runtime space for MPS data.!!.
System may operate in PIC or Non-MPS mode.
702
No enough APIC ID in range 0-0Fh can be assigned to IO APICs.
(Re-assigning CPUs' local APIC ID may solve this issue)
MPS Table is not built! System may operate in PIC or Non-MPS mode.
120 $A0CCMOS Cleared by Jumper. Restore the Jumper and Continue…
122 $A0CPassword Cleared By Jumper. Restore the Jumper and Continue…
POST related troubleshooting
Perform the following procedures when POST fails to run, displays error messages.
If the POST failure is during a routine boot up, check the following:
•
All external cables and power cables should be firmly plugged in.
•
The power outlet to the server should be connected and works correctly.