Hardware options installation 69
o
Slot 3
8.
Install the PCI riser cage (on page
25
).
9.
Connect the SATA cables to the SATA connectors on the system board.
For slot 2 and 3 cable routing, see "M.2 SSD SATA cabling (on page
82
)."
10.
Install the access panel (on page
21
).
11.
Do one of the following:
o
Slide the server into the rack.
o
Install the server into the rack ("
Installing the server into the rack
" on page
31
).
12.
Power up the server (on page
17
).
Redundant power supply option
Install the RPS backplane option to improve power efficiency and enable power redundancy. Power
redundancy requires the installation of two power input modules. This module is not part of the RPS
backplane option kit.
When this RPS backplane and a single power input module are installed in the server, you can install or
remove a second power input module without powering down the server.
To install the component:
1.
Power down the server (on page
17
).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Do one of the following:
o
Extend the server from the rack (on page
17
).
o
Remove the server from the rack (on page
19
).
4.
Remove the access panel (on page
20
).
5.
Prepare the server for removal of the existing power supply:
Содержание ProLiant DL120 Gen9
Страница 16: ...Component identification 16 Fan locations ...
Страница 24: ...Operations 24 o PCI blank 7 Remove any expansion boards installed in the primary riser cage ...
Страница 120: ...Support and other resources 120 ...
Страница 121: ...Support and other resources 121 ...
