Hardware options installation 67
8.
Align the PCI riser board with the corresponding connector on the system board, and then press down
the riser cage.
9.
Tighten the two screws to secure the cage.
IMPORTANT:
The server does not power up if the PCI riser cage is not seated properly.
10.
Install the access panel (on page
21
).
11.
Install the server into the rack ("
Installing the server into the rack
" on page
31
).
12.
Power up the server (on page
17
).
M.2 SSD enablement option
To install the component:
1.
Power down the server (on page
17
).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Do one of the following:
o
Extend the server from the rack (on page
17
).
o
Remove the server from the rack (on page
19
).
4.
Remove the access panel (on page
20
).
5.
Remove the PCI riser cage (on page
23
).
6.
Install the SSD module on the M.2 SSD enablement board:
a.
Insert the SSD module into the SSD slot at a 45 degree angle, and then gently press it down against
the M.2 SSD Enablement board.
b.
Secure the SSD module to the M.2 SSD enablement board with a screw.
c.
Repeat the process if you are installing a second SSD module.
Содержание ProLiant DL120 Gen9
Страница 16: ...Component identification 16 Fan locations ...
Страница 24: ...Operations 24 o PCI blank 7 Remove any expansion boards installed in the primary riser cage ...
Страница 120: ...Support and other resources 120 ...
Страница 121: ...Support and other resources 121 ...