HP HP ProCurve series 2500, Руководство по управлению и настройке

Страница: 214 / 392

9-20
Configuring Advanced Features
HP ProCurve Stack Management
Co
nf
ig
u
ri
ng Adva
nce
d
Feat
u
res
Using the Commander’s Menu To Manually Add a Candidate to a
Stack.
In the default configuration, you must manually add stack Members
from the Candidate pool. Reasons for a switch remaining a Candidate instead
of becoming a Member include any of the following:
■ Auto Grab
in the Commander is set to
No
(the default).
■
Auto Join
in the Candidate is set to
No
.
Note: When a switch leaves a stack and returns to Candidate status, its
Auto Join
parameter resets to
No
so that it will not immediately rejoin a
stack from which it has just departed.
■
A Manager password is set in the Candidate.
■ The stack is full.
Unless the stack is already full, you can use the Stack Management screen to
manually convert a Candidate to a Member. If the Candidate has a Manager
password, you will need to use it to make the Candidate a Member of the stack.
1. To add a Member, start at the Main Menu and select:
9. Stacking...
4. Stack Management
You will then see the Stack Management screen:
Figure 9-9. Example of the Stack Management Screen
2. Press [A] (for
Add
) to add a Candidate. You will then see this screen listing
the available Candidates:
For status descriptions,
see the table on page
9-49.