HP HP ProCurve series 2500, Руководство по управлению и настройке

Страница: 192 / 392

8-12
Configuring for Network Management Applications
Trap Receivers and Authentication Traps
Mo
ni
to
ri
ng
a
nd
Ma
na
gi
ng
the S
w
it
c
h
Configuring Trap Receivers
This command specifies trap receivers by community membership, manage-
ment station IP address, and the type of Event Log messages to send to the
trap receiver.
N o t e
If you specify a community name that does not exist—that is, has not yet been
configured on the switch—the switch still accepts the trap receiver assign-
ment. However, no traps will be sent to that trap receiver until the community
to which it belongs has been configured on the switch.
Syntax:
snmp-server host
< community-str > < ip-address > [<none | all | non-info | critical | debug>]
For example, to configure a trap receiver in a community named "red-team"
with an IP address of 10.28.227.130 to receive only "critical" log messages:
HP2512(config)# snmp-server trap-receiver red-team
10.28.227.130 critical
N o t e
If you do not specify the event level ( [<none | all | non-info | critical | debug>] )
then the switchwill not send event log messages as traps. "Well-Known" traps
and threshold traps (if configured) will still be sent..
Using the CLI To Enable Authentication Traps
If this feature is enabled, an authentication trap is sent to the configured trap
receiver(s) if a management station attempts an unauthorized access of the
switch. Check the event log in the console interface to help determine why
the authentication trap was sent. (Refer to “Using the Event Log To Identify
Problem Sources” on page 11-11.)
N o t e
For this feature to operate, one or more trap receivers must be configured on
the switch. See “CLI: Configuring and Displaying Trap Receivers” on page 8-11.
Using the CLI To Enable Authentication Traps.
Syntax:
snmp-server trap authentication
HP2512(config)# snmp-server trap authentication