Removing and installing an M.2 solid-state drive (SSD)
IMPORTANT:
If you are replacing an SSD, be sure to back up the data from the old SSD so that you can
transfer the data to the new SSD.
1.
Turn off the computer properly through the operating system, and turn off any external devices.
2.
Disconnect the power cord from the computer.
IMPORTANT:
Regardless of the power-on state, voltage is always present on the system board as long
as the system is plugged into an active AC outlet. You must disconnect the power cord and wait
approximately 30 seconds for the power to drain to avoid damage to the internal components of the
computer.
3.
Remove the computer head unit from the stand. See
Removing the Engage One head unit from the stand
on page 24
.
4.
Remove the display panel from the computer head unit. See
Removing the display panel on page 31
.
5.
To remove an SSD, remove the screw that secures the SSD to the system board (1), and then slide the
SSD out of the system board connector (2).
40
Chapter 3 Hardware configurations and upgrades
Содержание Engage One Retail System 143
Страница 4: ...iv About This Guide ...
Страница 8: ...viii ...
