cleaning
hp learning products
http://www.hp.com/support/tape
may have a later version
data protection
index of topics
contact hp
home page
before you start
operation
cartridge care
cleaning
specifications
media compatibility
diagnostics
troubleshooting
media compatibility
FAQs
SCSI configuration
UNIX configuration
ordering supplies
installing drivers
cleaning
contents of this section
cleaning strategy
cleaning cartridge
cleaning the tape heads on a drive
cleaning strategy
HP Surestore DLT VS80 drives have been developed to have a minimal cleaning
requirement. The
CLEAN/MEDIA
LED on the tape drive front panel will flash
when the drive needs cleaning. Under typical conditions, the drive should seldom
require cleaning. However, high duty cycles and adverse environmental conditions
may require the drive to be cleaned on a regular basis to ensure optimum
performance is maintained, and it is therefore considered good practice to clean
the drive approximately every two weeks.
IMPORTANT:
It is essential to use only DLT VS or DLT1 cleaning cartridges with
HP Surestore DLT VS80 tape drives. Cleaning cartridges from other media
manufacturers will not be accepted by the drive (see the
media compatibility
page
for full details). Use of HP cleaning media will ensure your tape drive is fully
protected.
cleaning cartridge
You must use
only
DLT VS or DLT1 cleaning cartridges to clean the tape heads
(see
Ordering Information
). A cleaning cartridge is supplied with each tape drive.
Do
not
use swabs or other means of cleaning the heads. The cleaning cartridge
uses a special tape to clean the tape heads.
A cleaning cartridge can be used up to 20 times. The cleaning cartridge includes a
label with 20 small boxes printed on it. Always place a check mark in a box each
time you use the cartridge to clean the drive. Replace the cleaning cartridge when
all the boxes are checked.
cleaning the tape heads on a drive
The drive's TapeAlert feature sends a message to your backup application when
the tape heads need cleaning and the Clean/Media LED flashes. To clean the tape
heads:
1.
Insert a DLT VS or DLT1 cleaning cartridge into the drive. The tape drive
automatically loads the cartridge and cleans the heads.
Note
: If you insert another type of cleaning cartridge, the Clean/Media LED
turns off and no cleaning will be performed. Ensure that cleaning is
performed only with DLT VS or DLT1 cleaning cartridges.
During the cleaning cycle the Clean/Media LED flashes. At the end of the
cleaning cycle, the Clean/Media LED turns off to indicate that you should
remove the cleaning cartridge. The cleaning cycle can take several minutes.
2.
Remove the cleaning cartridge from the drive.
If the Clean/Media LED starts to flash when you insert a DLTtape cartridge
immediately after cleaning, try a new DLTtape cartridge. If this condition
persists with other cartridges, use
HP Library and Tape Tools
to help you
diagnose the problem.
© 2001, Hewlett-Packard Company
file:///C|/Documents%20and%20Settings/topher.COL-SPRINGS/Desktop/dltvs80%20manual/document/dltvs80/user/reseller/eng/clean.htm [11/29/2001 8:33:56 AM]
