HP C2858A, Руководство по обслуживанию

Страница: 130 / 198

8-5
Troubleshooting
Table 8-1. Worded Error Messages (Continued)
Message Error/Action
Media too small Media loaded for accuracy calibration or pen alignment is too
small. Reload appropriate media.
Mispositioned
Reload roll Roll is mispositioned. Unload roll media. Open the roll cover
and push the media roll all the way to the right so that it is
flush against the media stop on the roll core. Reload media
with the right edge no more than 0.2 inches (0.5 cm) from the
perforated line on the entry platen. Remove any ink deposits
on the drive roller. Ink deposits are reflective and can give
false indications for detecting media edges.
Mispositioned
Reload sheet Sheet is mispositioned. Remove it and reload it with the right
edge no more than 0.2 inches (0.5 cm) from the perforated
line on the entry platen.
MIO data error The modular interface is configured incorrectly. Press the
ENTER button to clear the message from the front panel
display. Recheck the MIO configuration settings.
MIO error
Comm. break The flow of data from the computer to the plotter was
prematurely stopped (e.g. by switching OFF the computer
before all of the data was sent). Press the ENTER button to
clear the message from the front panel display.
MIO error
Handshake The modular interface is configured incorrectly. Press the
ENTER button to clear the message from the front panel
display. Check the handshake settings in the plotter’s front
panel, in the hardware configuration, and in the application
software configuration. Adjust the settings as needed to
ensure compatibility.
Out of memory
Data was lost The current plot is too large for the plotter’s buffer.
Additional memory must be installed to plot drawing.
Pen (C, Y, M, K)
not loaded Pen checking is ON and an error has been detected. Press the
UP ARROW if you want to load the pen. Press the DOWN
ARROW if you want to continue without loading the pen.
Remove media
Lower lever An attempt to load media was made while the media load
lever at the right of the plotter was raised. Remove the media,
lower the lever, and reload media with the lever down.