HP 64782, Руководство пользователя, Страница: 457 / 554

Disable breakpoint failed: %s (604)
Cause: System failure or target condition.
Action: Run performance verification (Terminal Interface pv command), and
check target system.
Disable breakpoint failed: %s (666)
Cause: System failure or target condition.
Action: Check memory mapping and configuration questions.
Display register failed: %s (634)
Cause: The emulator was unable to display the register you requested.
Action: To resolve this, you must look at the other status messages
displayed. It’s likely that emulator was unable to break to the monitor to
perform the register display. See message 608.
Don’t care number unexpected
Cause: While defining an expression in your command, you included a don’t
care number (a binary, octal, decimal, or hexadecimal number containing
"x"), which was not expected. Don’t care numbers are not valid for all
commands. See the EXPR command syntax for more information about
expressions.
Double bus fault -- fault address register: ________ (157)
Cause: A double bus fault occurred because of multiple address or bus
errors. When this occurs the emulator breaks into the monitor.
Emul700dmn continuation failed
Cause: Communication between the emulator and the host system to
continue the emulation session failed.
Action: Check the data communication switch settings on the rear panel of
the HP 64700 series emulator. If necessary, refer to the
HP 64700
Installation/Service Guide .
Error Messages
456