20
should not be made before the bow has been shot a minimum
of 100 shots.This will allow the mating surfaces of limbs and
riser to correctly seat to each other.
To make a lateral adjustment, follow these directions:
1. With your bow in the strung position, place a piece of
masking tape horizontally, approximately 4” (10cm) from the
end of the riser on the archer’s side of both limbs.
2. Locate the center of the limb with a measuring tape and
draw a vertical center line on the masking tape.
3. Measure 1/16” (approx. 2 mm) from the drawn vertical
center line and draw additional vertical lines on both left and
right sides.
4. If the bow string lines up with
the center line, your dowels are
properly aligned. If you notice
conditions A or B, proceed with
the following directions.
5. Unstring the bow utilizing an
appropriate bow stringer and
remove the limbs (See page 15).
6. Loosen the radial locking
screw.
7. Unscrew the alignment locking
screw and remove the alignment
cap and washers. Pull the align-
ment dowel and washers out from the sight window side of
the pocket.
8. Instructions for CONDITION A: Remove a washer from the
right side of the dowel and add it to the left side of the dowel
(see page 15).
9. Instructions for CONDITION B: Remove a washer from the
left side of the dowel and add it to the right side of the dowel.
(see page 15).
Note: To correct the alignment only add washers to the side
Condition
A
Condition
B