horsch LEEB 12 TD, Руководство по эксплуатации, Страница: 90 / 181

Assembly accessories
1
2
3
4
1 Self-adhesive plate
2 Magnetic base
3 Metal plate
4 GPS receiver
1. Thoroughly clean the location where the GPS
receiver shall be mounted with alcohol.
¾
for installation on the tractor: centred on
the front of the roof
¾
for installation on the crop protection
sprayer: on the carrier plate of the
crossbeam
2. Glue the double-sided self-adhesive plate (1)
on the cleaned surface.
3. Clean the metal plate (3).
4.
Pull the paper off the self-adhesive plate (1)
and glue the metal plate (3) onto it.
5. Screw the magnetic base (2) into the GPS
receiver (4).
6. Position the GPS receiver (4) with the
magnetic base on the metal plate (3).
GPS receiver mounted on the carrier plate of the
crossbeam
Connecting the GPS receiver to the terminal
CAUTION
The plug of the terminal carries voltage.
Damages to the terminal may occur from
a short-circuit.
Switch off the terminal before connecting the
connecting cable of the GPS receiver to it!
1. Switch off the terminal.
2. Route the connecting cable of the GPS
receiver into the vehicle cabin.
3. Connect the connecting cable to the RS232
port on the terminal.
¾
For more information about the right
connection, refer to the HORSCH Terminal
TOUCH 800 or Terminal TOUCH 1200
operating instructions.
4. During initial starting it may take up to
30 minutes until the GPS receiver has
reception. For all other starts it will only take
approx. 1 - 2 minutes.
NOTE
Information on the configuration of the GPS
receiver is provided in the associated terminal
operating instructions.
Technical data
Features
Operating voltage 7 - 36 VDC
Current consumption 249 mA at 12 VDC
Power consumption < 3 W at 12 VDC
GPS Standard
NMEA 0183
Configuration
Frequencies 5 Hz (GPGGA, GPVTG)
1 Hz (GPGSA, GPZDA)
Transfer rate 19200 Baud
Data bits 8
Parity no
Stop bits 1
Flow control none
86 87